All 2st Please post pictures of your 2 stroke bikes.

Nice!

So you guys could see it?

I tried to post a picture but I couldn't see it. I'll try again...

My 2008 CR 125



My 2006 CR 144



That sucked there has to be an easier way to get a URL? My fault on the deleted post.

You are exactly correct.

My 2006 144 from Eric Gorr was amazing. The stock 2006 was lacking in the bottom to mid. I am 6' 200+lbs. with gear. I added a FMF Fatty pipe and silencer. Power Now in the carb, porting, polishing, etc. And had a difficult time with jetting. But as far as mods go it was a must.

My 08 CR 125 has no engine mods and runs like my 144. I have Power Now in the carb and FMF exhaust but thats it. So I guess thats the difference in the new cylinder?? I'd hate to see what it would run like with a kit in it....

I saw them the first time, but they were small. I'm going to ride mine stock for awhile except for jetting and Power Now. I still think I may end up with a 144 kit at some point.

blue and white...looks pretty impressive...I would have never guessed....maybe when I bin one of my bikes and need plastic.....I'll try that

Question....Hey blue are you running...washougals...or carlsbads.......kendas that is??? ........if so..what are they like?

Troy F Collins

I run Millville's since I live in Illinois. Great Soft to Intermediate. I have ran the Southwick in U.P. Michigan sand which worked great. I have never ran the Washougal but I plan too this year b/c I'm riding the National Enduro Series. And as far as the Carlsbad goes, I tried it one time during the summer at a hard pack course and it was junk!!

I see you still have the stock drivetrain. I strongly recommend Dirt Tricks Ironman rear sprocket and Regina O-ring chain.

I'm darn well hoping so, by jingees!

My 08 wr250

Here's my 88 WRK 125. Had it for over 20 years now. Still a fun bike if the hills aren't too big. Had to replace the ignition about 5 years ago. Put a piston, chain, sprockets on it once. It sat in a barn for 10 years unused. I probably ride it about 60 miles a year. Maybe enough to burn a tank of gas. I think I got my money's worth out of it. I'll have some other posts for the other 2 strokes.

Yes it is. You need a plate to ride off road in Alberta. I am just to lazy to remove it when I am racing.

Xriderown WR360

This is my 2000 WR360 with 04 plastic.

My 06 WR125


in the snow


when new

Fresh outta tha crate. Twas such a great day.

In action...

I've got 08 shroud graphics on the way to get that CH Racing look.