2010 TXC 250 Update!!!

Got my IBeat software in from Semco Des. this morning

Talked to Scott on the phone as I was having some interface issues with Vista on my laptop. Ended up downloading it to an XP laptop and works just fine.

Changed Co settings to 108/110/110, just to do an initial, quick test and check to see if the low end bog would go away....

Initial impression: Is this a 450 or a 250? This thing seems to have gotten a deeper exhaust note (Good thing) and sounds like a much bigger bike

Did some quick throttle twists and it hesitates only very slightly, but does not stall or do what it use to do, which was flame out....Wow, very nice now.

Now the fun part: Riding....I have only done a couple quick, low end hot laps around my house..... WOW, the low end bog/hesitation is GONE This thing efi's cleanily, with my initial baseline settings....DOnt know about the mid and top end yet, but it should be just as good (It was already good before)

I cannot believe how clean it runs now on the low end...Very nice, no bog, no nothing, but sweet Husky power to kick all those little Honda's around in Tecate tommorrow Just kidding Honda riders, i'll try not to roost you all to bad....

Enough writing, gotta get back to more riding



Mitch

iBeat normally works fine with Vista. There is something unique with his Vista system that wouldn't allow iBeat to install correctly. This is the first time a problem like this has shown up.

I'm glad to hear iBeat tuning is making improvements for you. Keep us updated.