250-500cc 1992 husqvarna wxc 360 torque specs

I have a 1992 WXC 360 and I need to figure out the torque specs for the head and the flywheel nut. I was looking for an owners manual but I could not find one anywhere, just parts catalogs. does any body know where i can find an owners manual or know the torque specs?

I also have a '92 360, finding a year specific manual has proved fruitless for me. I settled for a '99 manual. Considering aside from porting and ignition the motor didn't really change during it's 12 year run all torque specs should apply. My manual lists the cylinder head bolts as 6.5-7.2 ft-lb and the magneto nut as 54-61 ft-lb. Hope that helps.

the motor really was very similar, to the point you could put a 99 top end on it and it would be just about the same, would fit the chassis etc.
for a 92 the 93 book would work, different kickstand, exhaust (valve) and exhaust port but most of the rest is the same

Head bolts I do too 18-25nm and flywheel just do up with 19mm spanner as hard as you can....

Thanks guys, this was really helpful. I have been struggling to get this bike going for a while.

Where you based gmoon? If your local to anyone or can get the bike to a race meet im sure someone will be willing to help.
For a few beers etc

If you need a manual yell out...have on my google drive.