250-500cc 2000 WR-360 Oil Site Glass

I purchased a new outer clutch cover for my 2000 WR-360 and it did not come with the oil site glass. Is there a trick to removing the site glass from my old cover and installing into the new one, or will I need to order a new site glass?

Mike

The sight glass is encased in rubber, with a little leverage on the metal cage and it will came right out - the same as pressing in/out a bearing.
Pull it out evenly from both sides. Wiggle a little on this side, wiggle a little on that side and so on - with patience it will come out surprisingly easy.
Without patience, then it's a case of ringing your husky dealer for a replacement sight glass, drill a small hole in the centre of the old one, plug a screw through and smash it out!! Then measure up the diameter and hole your new cover, use a bit of sealant (oil and heat resistent) and apply a film to the new rubber gasket and to the sight glass, then push it all in.

PS. You cannot remove the sight glass from the inside of the case.

Thanks for the info.

Mike