1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

250-500cc 2001 WR-360 Assembly

Discussion in '2 Stroke' started by oldmx, Jul 6, 2012.

  1. oldmx Husqvarna
    AA Class

    Location:
    Fargo, ND
    Husqvarna Motorcycle:
    2001 WR-360.
    Other Motorcycles:
    2009 KTM 505
    I am in the process of putting my 360 back together. However, I cannot get the swingarm to fit back into its home. Does anyone have any tips? It appears that I am 1/4 inch too wide and I cannot get it to slide between the frame and motor.

    Mike
    oldmx, Jul 6, 2012
    #1

  2. kiethy Husqvarna
    B Class

    Location:
    Australia
    my 01 250 required a rubber mallet and levers, bit of spring in the frame I guess:excuseme:
    kiethy, Jul 6, 2012
    #2

  3. jo360 Husqvarna
    AA Class

    Location:
    perth australia
    Husqvarna Motorcycle:
    1983 exc framed wr430 engine
    Other Motorcycles:
    ktm 520exc
    use rope and a chainblock or tirfor, attach rope to one side of frame and tirfor to other side both attached to something solid and pull apart.
    jo360, Jul 7, 2012
    #3

  4. oldmx Husqvarna
    AA Class

    Location:
    Fargo, ND
    Husqvarna Motorcycle:
    2001 WR-360.
    Other Motorcycles:
    2009 KTM 505
    Thanks for the above advise, I ended up using a sissor jack which worked great. However, when I let pressure off the jack the swingarm barely moves. I have checked Hall's site and it appears I have everything in place. Looking at page 92 for a 2001, I have numbers 2 and 53 on the inside of the swingarm and numbers 56 on the outside. Is this the wrong setup? Does anyone have a photo of their swingarm so I can see if I have mine assembled wrong. Thanks for the repiles.

    Mike
    oldmx, Jul 8, 2012
    #4