2003 TE610 carby question.

Discussion in 'EFI/carb' started by Muzza8, Nov 29, 2015.

  1. Muzza8 Husqvarna

    Husqvarna Motorcycle:
    2003 TE610
    Hello to everyone. This is my first post on the forum
    I have a Aus spec 2003 TE610. I purchased a carby rebuild kit recently and it came with a small copper washer (7mm od, 4mm id and 0.3mm thick. I can't see where it goes in my carby. The carby is a Dellorto PHM40
    Thanks.
  2. BILLF CH Sponsor

    Location:
    BMP Husqvarna, Salem, OR USA
    Husqvarna Motorcycle:
    92WXC350 /Lamson CR250/701 Vitpilen/
    Other Motorcycles:
    Triumph900 Scrambler 1200 HD Nightst
    Does it go on the bolt that holds the fuel/filter gas spigot on the sode of carb ?
  3. Muzza8 Husqvarna

    Husqvarna Motorcycle:
    2003 TE610
    Hi BILLF. I had a look but it is a bit small to go in there. The kit I purchased is a Dellorto COD 52520.77. I am thinking that it might suit several different carbies?