250-500cc 2009 wr 300

Does anyone know where I could find the right torgue numbers for the nuts and bolts of this beast??

Good question. I hadn't found any, but having another Husky, I went over every fastener on the bike when I got it home last summer. I applied anti-seize to all the bolts going into those "nutserts" set in plastic (e.g., the tank, the fender to airbox, etc). On anything that will harm you if it were to loosen in flight, I used thread locker. Admittedly, I did most of it by feel. On the axle nuts, I did those up with the axle wrench I'd use in the field.

PM me your email address. I have a torque value cheat-sheet for the bike.

Edit: Loctite is your friend with this bike. Especially on the motor mount and subframe bolts!