125-200cc 2011 Cr150 Crank Specs?

Just picked up a 2011 CR150 with a known need for a “top-end”. Took the head off... clearly it was quite the ‘nip-up’... nikasil is gone on the exhaust side. Will need a recoat.

Don’t have a manual yet, and wondering if one of you gents could provide me with the crank spread spec?

Many thanks!

looked at that little beauty- you were faster

emailed within an hour of posting. Lol. Got lucky.

I have since found the crank spec. Seems to be the only think on the bike that doesn’t need attention... hopefully will have it on the trail with ALL wear items replaced. Still a pretty good deal in the end I’d say. Market value wise. Never had one of these, hope it’s all it’s reported to be.

For completeness of the thread, crank spread/big end gap spec is 0.45-0.85mm. 1mm is the service limit.

I am worried about the cause of the seize. Jets seem fat and it was in the summer apparently. Replacing crank seals for safety.

might have been no oil in the 'premix'

Seems it wasn’t the only area lacking lube