250-500cc 2011 WR250 jetting

Hi Guys,
I searched around but didn't find anyone discussing 2011 250 jetting. Anyone get these all figured out? I'm pretty experienced with this type of stuff, but I always like to hear what others have come up with. I'm in S. CA and usually ride at around 2000 ft.

Here's what's in it
380 main
17.5 pilot
6CFY5-74 needle clip in #3 (A 6GAY69-74 also came with it)
5.0 slide

In my 09 I've been running
400 main
35 pilot
6BFY43-74 needle clip in #2
4.0 slide

Thanks.

Have you ridden it yet? There is a jetting update to do on that bike. Chances are it will seize up with that jetting.

Haven't ridden it yet. I have the jetting kit, I'm just wondering what everyone is running.

I wonder if the new digital ignition has anything to do with the different jetting.

My 09 is similar to yours

Year & Bike Model = 2009 WR250
Carb = Mikuni
Pipe & Silencer =Stock
Other engine mods = none
Premix ratio & fuel type = 32:1 Lucas synthetic blend & VP 110
Temperature range (deg F) = 70 degrees F humidity 50%
Elevation (feet) = actual altitude is 1,100 ft. air density altitude is usually between 1500ft and 2500ft in this area but I have seen 3500 ft air in the humid summer.
Main jet =420
Pilot jet = 32.5
Needle = E16BFY43-74 stock
Clip position = 2nd clip with 1/2 step washer/spacer
Air screw setting = 1 1/2
Slide = stock 4.0

Interesting. That looks like the jetting in the restricted model. Did other jets come with it too?

In my 09 at 6000 ft I'm using the GAY needle in the 2nd, and 30 Pilot. I have been using a 360 main, but I need to check that again since I just adjusted my powervalve.