1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

125-200cc 2012 CR 125 handlebar bend

Discussion in '2 Stroke' started by flyingbob, May 25, 2020.

  1. flyingbob Administrator

    Location:
    USA
    Husqvarna Motorcycle:
    01&02WR360_02WR250_02CR250_12WB165
    Other Motorcycles:
    01 VOR400_07 TM450_22 GG250_07 Tuono
    Anyone know measurements on the Magura bars that came stock on a 2012 CR125, maybe also on a TC250? Compared to any ProTaper or Mika bars?
    Thanks
    flyingbob, May 25, 2020
    #1

  2. jeanjean Husqvarna
    AA Class

    Location:
    Netherland
    Husqvarna Motorcycle:
    WR 125
    Other Motorcycles:
    IT175H
    [IMG]

    SX-bend.

    But take care when comparing with Renthal or other, the value f1 is an overall value and not mid-to-mid. The value h maybe as well.

    So you have to deduct 22.2 mm to compare.

    jeanjean
    jeanjean, May 25, 2020
    #2

  3. Giack Husky310R Husqvarna
    AA Class

    Location:
    Piemonte, Italy
    Husqvarna Motorcycle:
    TE310R EVO2-TE 310R MP19-WR300 SB
    Other Motorcycles:
    Ktm 300 factory 2011
    I've measured mine of a 2013 310R and has the same dimensions of the renthal 994 or 826 fatbar
    Giack Husky310R, May 25, 2020
    #3
    flyingbob likes this.

  4. jeanjean Husqvarna
    AA Class

    Location:
    Netherland
    Husqvarna Motorcycle:
    WR 125
    Other Motorcycles:
    IT175H
    I changed my bar for the Protaper 020206 (Husqvarna stock) mounted on the Austrian Husqvarna (same bend as the Neken of the KTM).

    I was not happy with the control area of the Magura bar, not allowing me to move the clutch lever far enough to the mid.

    I found the Magura a bit to high and the Protaper a bit to low, so i put the 10 mm collars below the clamps.

    jeanjean
    jeanjean, May 25, 2020
    #4
    flyingbob likes this.