1. 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
    TE = 4st Enduro & TC = 4st Cross

2012 Tc250 Run Issue

Discussion in '4 Stroke' started by S-Jersey rider, Nov 12, 2020.

  1. S-Jersey rider Husqvarna

    Husqvarna Motorcycle:
    2012 tc250
    Other Motorcycles:
    ktm 350 exc-f
    Recently obtained a 2012 tc250. Bike will start and run but will cut off after idling @ minute. Idle speed set where it needs to be. If given throttle in neutral it will stay running till let off throttle. If bike ridden it will shut off after a short ride when pulling in the clutch. When started the idle sounds good, but will have an intermittent miss. Also is harder to start after it stalls. Spark plug replaced to rule it out. Thinking issue may be stator. Book provides limited info for testing but ohms test on yellow wires is 1.4-1.6 book calls for .6. Any thoughts before I replace stator.
  2. joedirt Husqvarna
    AA Class

    Location:
    PA
    Husqvarna Motorcycle:
    wr250
    Dirty injector can cause issues that make you think its something else.
  3. cordia Husqvarna
    C Class

    Location:
    Durban SA
    Husqvarna Motorcycle:
    TXC 310 2013
    Other Motorcycles:
    KTM GasGas Honda
    Hi get a new Petrol filter in... maby a new injector as well ... if the bike is old check the inlet valves I had the some problems.. after that ... I but a new TPS sensor near the timing chain Problem gone ! send update reg
  4. S-Jersey rider Husqvarna

    Husqvarna Motorcycle:
    2012 tc250
    Other Motorcycles:
    ktm 350 exc-f
    May have to look in that direction it is just that idles so well when it starts and runs really well too, but then when hot pull in clutch to shift and shuts off. Idle same start it up idles great for 30 seconds then a miss or two then shut off. Then seemed difficult to start when hot and shut right back off. Doesn't seem like your typical fuel issue, but i guess this week ill try to take a look at injector before investing in stator.
  5. cordia Husqvarna
    C Class

    Location:
    Durban SA
    Husqvarna Motorcycle:
    TXC 310 2013
    Other Motorcycles:
    KTM GasGas Honda
    My Bike than the some thin difficult to start when hot ..running lean backfiring etc when cold idling perfect around the block but after 5 - 10 minutes startet to backfire like hell I gone to all fuel issues etc. Then i but this Temp sensor ( white socket ) what goes in to ECU .. Bike is perfect now
  6. S-Jersey rider Husqvarna

    Husqvarna Motorcycle:
    2012 tc250
    Other Motorcycles:
    ktm 350 exc-f
    I believe my bike only has an air temp sensor that goes in airbox/intake. Is that what you are referring to? Going to try to check injector tomorrow if I get time.
  7. cordia Husqvarna
    C Class

    Location:
    Durban SA
    Husqvarna Motorcycle:
    TXC 310 2013
    Other Motorcycles:
    KTM GasGas Honda
  8. cordia Husqvarna
    C Class

    Location:
    Durban SA
    Husqvarna Motorcycle:
    TXC 310 2013
    Other Motorcycles:
    KTM GasGas Honda
  9. cordia Husqvarna
    C Class

    Location:
    Durban SA
    Husqvarna Motorcycle:
    TXC 310 2013
    Other Motorcycles:
    KTM GasGas Honda
    Oh shit your are right!! 2012 has no sensor sorry I m wrong I looked at 2013 soory
  10. S-Jersey rider Husqvarna

    Husqvarna Motorcycle:
    2012 tc250
    Other Motorcycles:
    ktm 350 exc-f
    Ok checked out the injector and it appeared ok and clean for what thats worth, but realized the crazy thing that it DOES have a water temp sender although I from what I have seen didnt think it should. Ill probably replace.
  11. joedirt Husqvarna
    AA Class

    Location:
    PA
    Husqvarna Motorcycle:
    wr250
    How did you check the injector?