1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

All 2st 45mm Zoke fork seals

Discussion in '2 Stroke' started by PowerKord, Jun 4, 2014.

  1. PowerKord Husqvarna
    AA Class

    Location:
    Notheast Ohio
    Husqvarna Motorcycle:
    2008 WR 250 Sold
    Other Motorcycles:
    2014 Sherco SE-R 250
    I'm about due for a fork rebuild. I was wondering if most people prefer stock oil/dust seals or something aftermarket such as available from All Balls. Thanks!
    PowerKord, Jun 4, 2014
    #1

  2. Phaeton Husqvarna
    AA Class

    Location:
    Bend, Oregon
    Husqvarna Motorcycle:
    2007 wr 250
    Other Motorcycles:
    2011 GASGAS EC 300 2007 KTM 200 XC
    I know LTR only uses stock components.

    I have used All Balls and have had good results.
    Phaeton, Jun 4, 2014
    #2

  3. uranys Husqvarna
    AA Class

    Location:
    Pittsburgh, Pa
    Husqvarna Motorcycle:
    00 wr360/02 wr360/09 wr125/09 wr250
    Other Motorcycles:
    96 xr600r
    I've got a set of the skfs on my 250. They are expensive (around $70 for seals and wipers) but they have lasted a long time. Stock (NOK) seals last a while too but have more stiction than the skfs.

    I've tried the all balls seals a few of times and they always end up leaking after a couple rides.
    uranys, Jun 5, 2014
    #3