84 wr250 kickstand length

can someone measure the length of theirs for me?
mine is missing and i have a few of the later liquid ones, thinking i can cut one down to fit..thanks guys

You mean the steel one, right ?

yes the steel kickstand, not a kickstarter.

It is about 16" from the bottom to center of bolt.

thank you sir, that saves me some trial and error and i can get the stand coated along with the frame/swinger..

Correct. 16 inches

41 cm....sorry to be late, justintento.......

thanks for the solid confirmations guys...i guess another question i should have asked..how far down is the spring tab?

The Mogly460 photo shows it is about 4 inches down from the pivot hole.

looks like about 3 to me, but i really dont want it being off.

Sorry, I'm away on vacation now - I'll get back to you this weekend if no one replies in the meantime.

no problem..the donor single shock kickstand has a mangled up pad...so i still need to cut some swedish steel from a junk frame for a new one.

Some pics for you...
..

I put my 85 on the 79 wr and it fit perfect but I did raise the entire bike with the 40's up front and a longer shock eye. I really don't like when the bike leans so far over . It's really up to you J unless your restoring it. Remember your spring may not be the same as their's so just tack it where it is nice and tight and check to see how it works then go back and weld it up. Good luck.

Looks like RUF got you covered, but here is another photo to confirm consistency. It measures 3.35" from bolt center to spring hole center.

thanks for taking the time sir