125-200cc Adjustable Clutch Perch for 2014 CR125?

Hey guys, anyone know what Adjustable Clutch Perches will fit the new Cr125's? I tried the works connection Elite Perch system i have always used on all my bikes after talking to Works Connection and them assuring it would work and it doesn't. Any info would be great, i have also used the ASV C6 set up but don't want to spend $135 if it wont fit.
Thanks
Bubby

I know I had problems on mine with the asv lever.
I couldn't get the free play required and it slipped clutch

Yeah i was afraid of that, same thing with the works connection, almost seemed like the cable is to long, but for a fact the threaded cuplink that twists to adjust the play is 1/4'' shorter.

And beyond the adjustable cable, does the 125 have the adjustable throwout rod like the 250/300/360 does? An 8 or 10mm nut with a flat head screw in the middle at the center of the clutch?

When I changed to an ASV F4 setup on mine, I had to take adjustment at the throwout as the cable did not have enough range.

I havent found any purch that would work with stock cable except the stock one. Motion Pro can make you any cable you want. Just give them all the specs and it isnt expensive either.

The standard cable does have an in line adjuster in the middle . I had to wind it right out and then the clutch was pulling

So you can adjust the cable by adjusting the inline adjuster, the problem i ran into before is where the cable came out of housing was to long. I'll try tomorrow before i do my moto's and see if it works.
Thanks
Bubby

The zeta clutch perch assembly fitted straight up (expensive though)

ARC clutch perch works fine for me

Anybody have the Renthal Gen2 intellilever clutch assembly on there bike or the RL1 works perch?

Anybody tried the Pro Circuit or MSR? Just saw both on motorcycle.com