Barnett Clutch Cable

Discussion in '610/630' started by jerbear610, May 25, 2010.

  1. jerbear610 Husqvarna
    Pro Class

    Location:
    Sacramento,CA
    Husqvarna Motorcycle:
    14' WR300, 11' TE511, 06'TE610 sold
    Other Motorcycles:
    11' Husaberg FE570, 15' Beta 300RR
    I just got a Barnett Clutch Cable and the ball end that connects to
    the arm down on the motor is bigger than the stock cable so I'm
    wondering if anyone else has used these and if so how do you connect it
    to the arm? Here's a pic of the two. Jerry

    Attached Files:

    jerbear610, May 25, 2010
    #1

  2. Motosportz CH Sponsor

    Location:
    Vancouver WA
    Husqvarna Motorcycle:
    2021 TE250i, 570 Berg, 500 KTM, 790R
    Other Motorcycles:
    many
    use a screw driver to slightly open the steel flange that holds it.
    Motosportz, May 25, 2010
    #2

  3. miketv Husqvarna
    A Class

    Location:
    Columbus, Ohio
    Make sure you check the alignment of the bracket that holds the cable to the clutch arm. Some brackets were mfg slightly out of alignment (mine) which caused the early failure. Also add a small dab of grease to the ball end, check the slot on the clutch lever for interference/drag when the lever is pulled in and you should be GTG :thumbsup:
    miketv, May 28, 2010
    #3