125-200cc center line of the gear selector Husqvarna wr 125

how to remove, replace step by step

First step to drain the engine oil

There are many photos can I continue?

The oil looked nice.
I would say to continue and try to sharpen the focus.

Why drain the oil to remove the shifter? Is that something unique to 2-strokes or to this bike? I have never had to drain the oil before to remove a shift lever but haven't tried it on my Husky yet and want to make sure because my lever is too high and is causing me to miss some up shifts.

Thanks for any info.

In the next pictures you will understand Lighterknot
This is not only to take the lever

Remove the cover when draining the oil

To drain the water from the radiators first step, take the radiator cap Turn the cap counter-clockwise

Loosen the screw to drain the water.
In a clean container

Here is a little complicated, but I gradually learned to post in order

Loosen the hose clamp and loose engine

Loosen the two springs leak

also loosen the 2 screws holding the exhaust

Take the pedal starting

Disconnect the brake spring on the chassis of the bike, and the bolt of the brake pedal

Roberto - Invest in a exhaust spring tool or just make one from a old spoke or even a coat hanger for when you put it all back together as your goimg to get really frustrated doing it with pliers

hes taking out the engine, hes removing a bent selector shaft not the lever.

keep it coimg Roberto

Thanks for the clarification. Can't wait to see the rest of it.