Chain Guide

I installed my new TM Design Works chain block for my TE 630 today and found that I picked the right time to replace the stock guide!
The bottom roller was seized and the roller had begun to seriously flat spot:


The upper rubbing block worn down to the mounting bolt:


The solution and new guide just bolts up to the oem bolt holes:

I've got one on my 310 and it works very well.

Nice. Looks similar to the BRP, which is what I use:

I use the same one.

Now, if they would only make a bash plate out of that material for the 610...

What material, the same as the slider?

I believe the BRP is UHMW.

The Hyde Racing skid plate is a similar polymer...

Go on the TM websit and look at the bash plates. It's much thicker than the Hyde one.

Hmm, never seen those... Not really digging the wingy profile, looks like it could snag more stuff, and they don't have one for the bigger bikes...

I have a TM Design Works skid plate on my TE310, looks and works great!

Just ordered a TM Designworks one. I had seen the BRP item, but as they didn't have APO shipping options and haven't replied to my email about shipping, I went with TM Designworks. They had AE in their address as standard.

Just buy the bloody Hyde one - it does not need to be any thicker. It is unbreakable. They are used on the extreme enduro bikes - Romaniacs, Roof of Africa, Ertzberg etc.