Chain roller wheel

I could use a few of these things at present. It used to be small and large and they were relatively cheap. The large one would be close to the size of spring loaded one on the front part of the swingarn, been a while since I had one of those assemblies mounted. This one was $15 and a few minutes standing there with the guy pushing keys and trying to extract as much information as possible. Look at the voids. Is this MSR the same Malcom Smith they send me on the cover of the AMA magazine.

A good solution was the plastic piece from say an 1999 husky and the bearings out something similar to the picture. Just the small one would work ok. Now I apparently need a lecture about how they are machine specific. I generally just have a block of something instead of the upper one.

I turned 1 up out of white nylon and threw some bearings in it