1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

125-200cc Electrical issue - WR 125 09

Discussion in '2 Stroke' started by OmerG, Apr 28, 2015.

  1. OmerG Husqvarna
    B Class

    Husqvarna Motorcycle:
    WR125
    Hi all,

    My speedometer turns on and off every few seconds in any RPM. In addition, in the last ride, when reached to the end of RPM, engine stalled when I pressed the clutch and turned on immediately when clutch released. I think maybe the two are related and I have an electric issue.
    Any ideas?

    Thanks!
    OmerG, Apr 28, 2015
    #1

  2. Miezie666 Husqvarna
    Pro Class

    Location:
    Germany
    Husqvarna Motorcycle:
    none
    Other Motorcycles:
    2x YZ 125, 1x YZ250 2005, XT600 2KF
    did u use the rear brake? my bike had a broke wiring loom for the tail light- just undo it and try again...
    Miezie666, Apr 29, 2015
    #2

  3. jeanjean Husqvarna
    AA Class

    Location:
    Netherland
    Husqvarna Motorcycle:
    WR 125
    Other Motorcycles:
    IT175H
    To avoid this kind of problems, and because I don't need it, I removed everything excepted the ignition parts (1, 12, 13, 17).
    I add a kill switch on the green wire comnig from the CDI/coil unit.

    But I don't know if I should keep the resistor located under the tank on the yellow wire (the one shown on the left top of the diagram, code 8000H1017).

    Anybody knows?

    Regards,

    jeanjean

    WR_wiring_diagram.png
    jeanjean, Apr 29, 2015
    #3