1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

125-200cc Float height??

Discussion in '2 Stroke' started by Philmooo, Mar 25, 2013.

  1. Philmooo Husqvarna
    B Class

    Husqvarna Motorcycle:
    WR 144
    Other Motorcycles:
    KTM 450 EXC
    What is the proper float height for the stock mikuni TMX 38 for the WR 144?

    Or what is the proper adjustment method? The carb was leaking fuel if leaned any farther than side stand angle. I adjusted the needle valve & float tang a bit but I am not sure it is where it needs to be.

    Thanks
    Philmooo, Mar 25, 2013
    #1

  2. Philmooo Husqvarna
    B Class

    Husqvarna Motorcycle:
    WR 144
    Other Motorcycles:
    KTM 450 EXC
    Oops I just found a bunch of post regarding this very issue. Sorry
    Philmooo, Mar 25, 2013
    #2

  3. pvduke Husqvarna
    Pro Class

    Location:
    ... on the gas...
    Husqvarna Motorcycle:
    tripple-hondo hoosk...
    Other Motorcycles:
    dozens of them, kicked to the curb
    only advice i got is when checking the level hold the carby is at a 45* angle or so...so it dont compress the needle spring when getting a reading, ya want it to juuust touch the seat. least that's what gramps told me. isolate the tang when tweaking. dont use the float lobes as leverage. you can do eeeeeet!
    pvduke, Mar 25, 2013
    #3