1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

All 2st Float hight of TMX 38 , please

Discussion in '2 Stroke' started by johnnyBgood, Mar 23, 2011.

  1. johnnyBgood Husqvarna
    B Class

    Location:
    Dallas , Ga
    Does anyone know the correct float bowl height of the stock 38 TMX carb of a 09 WR 250 , could it be in mm please . Thanks for any help husky dude,s .[IMG]
    johnnyBgood, Mar 23, 2011
    #1

  2. lankydoug Husqvarna
    Pro Class

    Location:
    MO
    Husqvarna Motorcycle:
    WR
    Other Motorcycles:
    TM 300en
    This isn't by any book but since the needle is spring loaded I just set my 09 WR250 so that it wouldn't pee out of the vent until the foot peg hit the ground. It was too high when new and would pee as soon as you leaned it half way to the peg. I was also getting horrific gas mileage before I set it and now it's not bad.
    lankydoug, Mar 23, 2011
    #2

  3. tommytwostroke Husqvarna
    AA Class

    Location:
    Pemberton, B.C. Canada
    Husqvarna Motorcycle:
    2010 WR125, 2017 TX300
    I'm w/lankydoug on this one!
    tommytwostroke, Mar 23, 2011
    #3

  4. dartyppyt Husqvarna
    Pro Class

    Location:
    Illinois
    Husqvarna Motorcycle:
    17 TE 150, 82CR 500
    Other Motorcycles:
    82 125,250,430&500 79 390 83 250
    20mm
    dartyppyt, Mar 24, 2011
    #4

  5. johnnyBgood Husqvarna
    B Class

    Location:
    Dallas , Ga
    Wow , mine now is 6mm in stock form , from bowl base to top of float upside down right when float tap just touchs plunger .
    johnnyBgood, Mar 24, 2011
    #5

  6. flatlander Husqvarna
    AA Class

    Location:
    Martensville SK
    Husqvarna Motorcycle:
    07 Wr250
    If you have the newer tmx with the kidnee shaped slide 6mm is correct. 18 to 20mm is for the original tmx carb, the squar slide tmx that my 07 has should be set at 14mm.
    flatlander, Mar 26, 2011
    #6