1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

250-500cc Fork oil height in WR300

Discussion in '2 Stroke' started by Kyspeedfactory, Jul 1, 2012.

  1. Kyspeedfactory Husqvarna
    B Class

    Husqvarna Motorcycle:
    2009 WR300
    Getting ready to do my fork seals on this 09 300 with 50mm Shivers....whats the oil height? normal like a KYB? 100mm... seems like my 04 TE250 was 110mm...
    Kyspeedfactory, Jul 1, 2012
    #1

  2. Gotlabs Husqvarna
    AA Class

    Location:
    Branchville, SC
    Husqvarna Motorcycle:
    12 CR144 X 2!
    I'm fat and run 110mm from the top. I think stock is 130.
    Gotlabs, Jul 1, 2012
    #2

  3. lankydoug Husqvarna
    Pro Class

    Location:
    MO
    Husqvarna Motorcycle:
    WR
    Other Motorcycles:
    TM 300en
    Stock is 110 or 120mm I think. I set mine at 130 and used 5 weight + make sure to clean the hard assembly grease from around the valving. I helped the harsh mid quite a bit by doing this but I'm still planning to send them off for a revalve soon. You can always add 5cc at a time back through the air bleeder if it's too mushy for your liking.
    lankydoug, Jul 1, 2012
    #3

  4. robertk61 Husqvarna
    A Class

    Location:
    Melbourne, Australia
    Husqvarna Motorcycle:
    09 WR250
    +1
    robertk61, Jul 2, 2012
    #4

  5. ray_ray Mini-Sponsor

    Location:
    The Philippines
    Husqvarna Motorcycle:
    08\013 WR250, 010 TC250, 012 TC250
    Remember, less oil means more air in the fork... Air is compressible so it cushions the ride ...

    My fork stacks are set a little hard because I ride both MX and trails ... So I kept on lowering the oil amount till they got much softer on the trails ...
    ray_ray, Jul 2, 2012
    #5

  6. Kyspeedfactory Husqvarna
    B Class

    Husqvarna Motorcycle:
    2009 WR300
    Thanks guys...well I will prolly start at 120 and add as needed....easy to do....
    Kyspeedfactory, Jul 2, 2012
    #6