All 2st Handle Bars

Do any of you know what the stock specs of the handle bars that came on the 2009 wr 250/300? I'm looking to replace mine but don't want to get to high of a bend because of the tall bar risers that come stock on the Husky.....Or maybe what brand are they mine just say "centralized axis" on them.
Thanks.

I think these are the one's:http://www.domino-group.com/en/catalogue/handleBars_Detail.aspx?idmaster=3013

Confirmed......

yes domino bars

Anyone else run a bend close to the Domino bend ? I'm thinking about ProTaper Contour Windham bend or KX High bend.Thoughts?? Also does any one know how much the Dominos are to replace???

I use the Fly Areo Tapered part # 18-95432, they are 29 1/2 wide compared to the 31" stock bars but have about the same bend. They are just a bit taller than stock, maybe 10mm at the most. The difference in width is great it the tight trees.

I have some Fly KTM bend bars and they have what looks like the same bend and height as the stock bars on my 09 WR125.

Does anyone know where I can get bar end hardware to mount hand guards? The ID on these Axis Centralize bars is smaller than any others I have.

drill em

I do like a bit taller bar. I use the Moose Flex Series Mini bar. 29.5" wide. No cutting. Those are the bars in my avatar photo.

You could go Renthals? I still prefer the 7/8 bars due to the variety of bends available (currently jimmy buttons)
http://www.renthal.com/File/handlebars.asp

I tapped and installed a 3/8 helicoil then used a 3/8 stainless bolt from ace hardware. I have this on both of my bikes and it is the most secure hand guard mount I have ever had. They never try to rotate when you hit stuff.
I was taught this by ISDE veteran John Fero.
GP

Have those bars on my wife's bike. The only thing I don't like about them is the sweep. Makes the brake lever stick out at a weird angle, but they do have a nice height to them.

Mine have a fairly straight bend and I like bars with a straight bend. My levers don't stick out at strange angle. Maybe her's are bent ?

BRP one of our cafe husky sponsors makes a cool bar end deal.

+1 Drill them I think I used a 9/16 bit for mine when i installed the tusk d flex bar adapters

Put in a heli-coil and you don't need adaptors.
GP

This is the trick! I bought a tap and helicoil kit from Pep Boys. Bonus: made in USA! No drilling required - just tap, vacuum chips, insert coil and break tab; screw in and go. Many thanks WR...and I did not have to buy any China-made 9/16" bit (that's all they carry these days) found at the five hardware stores in town (not one had good USA-made bits), not to mention Lowe's and Home Depot.

Like I said before, not only is it easy, I have never had more secure hand guards. I also drilled another mount hole on the interior end of the guard( about 1/2" away) so the clamps still match the taper of the bars after narowing the bars.
GP

That's a great idea! I will be doing the same when I get my new cr125