All 2st Handlebar clamps

Has anybody used an aftermarket bar mount like Renthal to replace the stock mounts on a WR250-300? My stock top clamp is warped and I understand this is a common problem. Just wondering if there something more durable than stock. I just ordered the BRP nylon replacements for the stock rubber cones too.

I ran some BRP clamps on mine, and I think they were actually for a KX, but I don't remember for sure. BRP should know. It's just a matter of which size bolt you need to go through the cones.

I was wondering about the height difference too if any since the stockers are sitting up spacers.

I think they have different height clamps also. Again, BRP should know this, or you might even try Hall's. That's where I got my clamps.

Thanks, called Halls and they did have the BRP's but they are much shorter than the stock set up and to me the stock set up is already on the low side, so I just ordered a new stock top clamp.