125-200cc handmade pipe 125 pic (good or not)

I found this pipe on internet, it`s for a 99 125. can you tell me if fits on my wr 125 2000?
I know it´s dificult with pics but can you think they improve anything to the stock ones?

not sure about the pipe but those are some NICE shoes !!

tooo funny.

99 to 2002 are same. there are no 03's and 04 and up is different only in that the pipe /silencer junction is now where the 45 degree upward bend is in the tail end. (left side of the picture and above your nice shoes)
older pipes just need a cut and rework of the junctio to fit.
Joe

thanks joe...
but can you believe it can improve?250$!

DOMA used to make pipes in that fashion, are you sure its handmade?

yes it is

I've seen Dyno-port pipes that look a lot like that for the WR125. ????????

Hand made and Home made are two different things....

Creepy Razor

For $229 you can get a brand spanking new FMF Fatty in the USA direct from FMF, probably cheaper in an e-store. Even after adding shipping to Portugal it sounds like a better deal.

Changing the expansion chamber (pipe) design is one the single most effective ways to make power on a 2s.

I have a Dynoport for that bike an it does not look as custom as that.

It depends on the vintage and style. I've seen some that are total stampings, some half & half and some that were totally cone. Ten year ago they would build customs based off TSR software, but I'm not sure anymore.