Head torque spec needed

Does anyone know what the torque spec is for the head nuts and bolts on a 1983 wr250?

thanks

Just a thought since you haven't received an answer so far. On my 83 500, the 4 nuts torque to 24 lb/ft and the 2 bolts to 18 lb/ft. If I remember correctly my studs are 10mm diameter and the bolts are 8mm, so if yours are the same size, likely the same torque, but I don't know this for a fact.
The specs for these bikes came on a technical data sheet supplied with the owner's manual, hard info to find sometimes.

Steve

Steve is correct, general torque for a fastener that size is 18-22 ft/lbs.

Don't know which model your '83 WR 250 is, but my workshop manual says:
Model: Cyl head nuts (Nm): Cyl head screws (Nm):
MK 10500 - 19499. 40 ---
MK 19500+ 25. 20
ML 6000 - 15999. 25. 20
ML 16000+ 25. 20

FYI: 1 Nm = 0.7376 ft-lb.
Hope that helps...

JT

Thanks guy's, appreciate the help.

Sorry about the formatting of my earlier post...I'm new to this forum and haven't figured out how create a table yet ( it looked great before I uploaded it -- honest!!).

In case my info wasn't clear, here it is a different way: If your engine has 4 Cyl nuts and 2 Cyl screws, then it's 25 Nm on the nuts and 20 Nm on the screws. If your engine doesn't have the Cyl screws, then the torque spec for the head nuts is 40 Nm.

JT

83 Tech Specs, the attached PDF is far more legible.