Husqvarna Te 310 2011 Not Working...

Hello from poland i have a problem with husqvarna te 310 on injection mikuni
my girlfriend was riding 2 weeks ago and suddenly the bike died
I checked:
compression
fuel
new spark plug
resistance stator 0.6ohm
resistance the ignition coil, spark is ok
valve clearence in 0.15 ex 0.20
timing setting with time sensor
the electrical system seems ok
on Ibeat i have settings:
CO
100
100
100
Tps: ~990mv on cold engine, before my tuning tps was ~870
0 errors
the bike is trying start with no results
well.. could the driver be corrupted? I'm running out of ideas?
I can upload video when i try to start the engine

An engine is simple but still a pain in the A sometimes. If it has spark, its propably something with the fuel. If not its the electrics. On these bike the harness isnt bullet proof. Though you have spark so most likely you have problems with the injector or something around it. Does it gets fuel? Bad fuel pump? Clogged fuel line? Unscrew the injector and see if it works. I have no other idea.

Fuel is ok, when i try start engine sometimes make fire on exhaust but not started. I check the injection and it give fuel fog

if you have the Ibeat ckeck if the engine temperature is correct, errors etc..
ckeck if the fuel pressure is ok with a tester (3bar)