Hi guys, Got a 2010 TE450, had it since new. I'm trying to get Ibeats to talk to the bike using VW OBDC tool as discussed in detail elsewhere in the forum. However i recieve no communication popup. If the bike is running I don't get this but its not getting any data from the bike. Few years back when the bike was relatively new I had a fail message on the dash and took it back to the dealer. He could not communicate with the bike. I put down to a wiring issue as loom had rubbed over the throttle body. Now I've just fitted a new loom and was hoping for comms would be possible. I've played around with ground pins 4 & 5. 5 stops the no comms pop up when running. Any further suggestions. Got 12v across pins 5 & 6. Using Ibeat 2.1 on 32bit Win7 laptop.
