All 2st Lectron bowl upgrade

Got ally upgrade kit for my lectrons. Wats the go does the ally bit jus go between carb n bowl with rubber gasket between ally part n carb body? Then the bowl jus seals against the new ally bit?
The recess bit I assume is for the hose holders?

Can someone post a pic of theirs if possible please.

The alloy bit goes over the bowl - so the screws do up againts it and squeeze the bowl to the carb body so as to not let it fleex / bend as per without it mate.
See if I can dig out a pic when I get home.

found on the net - any help ?

Ahh you're a bloody genius mate. I was thinkin how the bloody hell does this make the bowl sag less?!

Thanks man

Where did you get this kit? I don't see it listed on Lectron's website.

Call or email them and they'll set you up.

i was starting to think this thread was written in a new aussie language!
i ordered one just for giggles a few months ago when ordering some choke parts. its a tight fit over the bowl!

New carbs come with the new bowl. I somehow snapped the PJ nipple on my older carb, sent it to Lectron for repair. They charged me for the repair, but went through the carb, cleaned, replaced a couple o-rings and the hoses, upgraded it with the new bowl and sold me extra rods at 1/2 price

i had one of the older bowls from 2 years ago, as i guess i just missed the new bowl update. theres a thread on here with pics of mine really drooping..the new corrected bowl has been fine but i figured while the carb was off id throw the "bowl ring" on..

Looks blingy n pushes saggy bowl up for sure! Anodised red would be sexy