LED tail light kicking me arse

Guys,

I've searched and read the sticky....found a few threads but still can't get this darn power up LED tail light figured out.

Here's what is coming out of my bike:

1 - brown
2 - light blue
1 - dark blue
2 - red and black tracer
2 - yellow
1 - brown

The tail light has the red, black and yellow three wire. I've tried all combos. I've gotten the running light the full on brake light and ever the running light that turns off when I pull in the brake?

So I've seen that some past posts mention the green coming out is power so would the brown fit the bill for 09? If someone could shed some sage advice I'd greatly appreciate it.

Coffee, don't know if this is the right forum or not so feel free to move. Thanks.

Lee

From the sticky here. Maybe the brown is same as the blue wires? Does this help?

If using the rear light that came with the power up kit it goes like this,,,,or this is what you'll need to get it all wired up. On the connector on the bike the wires go like this.....the red with the black stripe is the + for the right turn signal..... there is no black wire.... the blue wire is the ground for all the lights including the turn signals.....the lite blue is the + for the left turn signal....the yellow wire is for the running lights....and the green wire is for the brake light....


Now for the light itself......the red wire is the brake light.....the black is the ground..... and the yellow is the running light..........this info is from an 08 TE450...

Guys, I finally found the magic wire combo. For my '09 TE510 it was red (light) to yellow (bike), black (light) to blue (bike) and yellow (light) to brown (bike). Go figure.