1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

250-500cc mikuni tmx problems.

Discussion in '2 Stroke' started by fredd, Mar 11, 2014.

  1. fredd Husqvarna
    AA Class

    Location:
    PUERTO RICO
    Husqvarna Motorcycle:
    2016 kx 450f
    Other Motorcycles:
    1995 chopper
    i have a problem with the idle of my 2002 wr 250 because is high.the adjustment on the cable is all the way in, and if i close the air screw the bike still run great.if i open the air screw 1.5 turns the bike idle go higher. the carburetor is the stock one.
    fredd, Mar 11, 2014
    #1

  2. PowerKord Husqvarna
    AA Class

    Location:
    Notheast Ohio
    Husqvarna Motorcycle:
    2008 WR 250 Sold
    Other Motorcycles:
    2014 Sherco SE-R 250
    Did you try adjusting the idle screw on the carburetor?
    PowerKord, Mar 11, 2014
    #2

  3. fredd Husqvarna
    AA Class

    Location:
    PUERTO RICO
    Husqvarna Motorcycle:
    2016 kx 450f
    Other Motorcycles:
    1995 chopper
    i dont know where it is.
    fredd, Mar 11, 2014
    #3

  4. Dirtdame Administrator

    Location:
    Rock Springs Wy
    Husqvarna Motorcycle:
    11 WR300,13 WR125,18 FE501
    Other Motorcycles:
    17 Beta Xtrainer
    The idle adjuster is on the lefthand side of the carb, just above and slightly in front of the gas line pipe. It is locked in place by an 8 mm lock nut. Usually, adjusting it so the end of the screw is flush with the top of the nut gets good results. You need to have some slack in the cable adjustment, so that there is 3 mm of play at the throttle grip. Never use the cable to adjust the idle.
    Dirtdame, Mar 11, 2014
    #4
    msmith345 and shrubitup like this.

  5. fredd Husqvarna
    AA Class

    Location:
    PUERTO RICO
    Husqvarna Motorcycle:
    2016 kx 450f
    Other Motorcycles:
    1995 chopper
    ok i will try that thanks.
    fredd, Mar 11, 2014
    #5