125-200cc need help...had clutch apart '08 cr125

First off I think I may need to post some pictures for better illustration...I can't get no resistance to the clutch lever.Clutch cover is off,I believe the problem is where the ball bearing fits into a sleeved cylinder then the push rod fits into that.From the Manual it appears that there is another bearing and push rod?
At any rate as you can tell I'm bit of a rookie here,please fill me in.

There are 2 push rods and 2 balls, a flat roller bearing and a washer
the roller rides on. Usually the ball that fits in the top hat against
the end of the rod gets dropped on the floor and the other ball usually
doesn't come out of the shaft unless you remove it.