1. 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     TE = 4st Enduro & TC = 4st Cross

Need help! Slipper clutch install

Discussion in '4 Stroke' started by So Cal SM450R rider, Feb 28, 2009.

  1. So Cal SM450R rider Husqvarna
    A Class

    Location:
    So Cal
    Ok, so I finally get my slipper clutch that has been on back order since Dec. Its an Adige/Adler HU-52 for my 08 SMR 450. I follow the directions and even look at the install video from the website. I take out the old clutch pack and put in the new one. Everything is good until I put the original pusher back in followed by the pressure plate. The new pressure plate has a bearing in it which will not fit over the front of the pusher shaft. I think I might have the wrong pressure plate, (God I hope not) but I'm not sure. Not only that but there is a large black concave & grooved washer that came with everything and there is no mention of it in the directions. I don't know where it is suppose to go. Here are some pics of the pressure plate, 9 washers for the variable spring tention, the stock pusher, (which has its own bearing between 2 flat washers) and the black washer. Someone please help me!!!

    Attached Files:

    So Cal SM450R rider, Feb 28, 2009
    #1

  2. Coffee CH Owner

    Location:
    Between homes - in ft Wayne IN
    Husqvarna Motorcycle:
    2006 TE250, 2013 TR650 Terra - sold
    Moving from Tech ref to the 4st section.

    Tech ref is for keeping track of the handy "how to" info like checking valves & rejeting carbs. 4st is where questions are asked.
    Coffee, Feb 28, 2009
    #2