1. Husqvarna Motorcycles Made In Sweden - About 1988 and older

Numberplate rear fender ?

Discussion in 'Vintage/Left Kickers' started by highdez1981430cr, Feb 10, 2010.

  1. highdez1981430cr Husqvarna
    AA Class

    Location:
    Yucca Valley,Ca.
    while i was at the recent VMX race at Glen Helen i saw a husky with a rear fender that had numberplates molded into it.

    Anyone have a source for these?:excuseme:
    highdez1981430cr, Feb 10, 2010
    #1

  2. Husq.fleet Husqvarna
    AA Class

    Location:
    Pendleton Oregon
    --------------------------------------------------------------------------------
    Poached this from Lefty's reply on the photos page......
    DC Plastics has the Faulk replica rear fenders
    Husq.fleet, Feb 10, 2010
    #2

  3. frog Husqvarna
    AA Class

    Location:
    MN
    Go to the Can-am parts site RTRmoto.com they have shinny gloss white ones,much nicer then matte finish DC has.
    frog, Feb 10, 2010
    #3

  4. highdez1981430cr Husqvarna
    AA Class

    Location:
    Yucca Valley,Ca.
    Thanks guys!

    I will check both of them out.:cheers:
    highdez1981430cr, Feb 11, 2010
    #4

  5. wrx Husqvarna
    Pro Class

    Location:
    845 newyork
    Husqvarna Motorcycle:
    1973 to 1986 husky's various models
    Other Motorcycles:
    RM -250 / Buell / Penton 400 mc5
    M.ROBERT CAN-AM UNITS. also Pro Circuit used to sell em with their "hop-up" kit.
    wrx, Feb 11, 2010
    #5

  6. HuskyT Moderator

    Location:
    Corona, California
    Frog.... RTR only shows them in Can Am orange...do you have to ask for the white?

    How is the fit up? Any firsthand knowledge? Any trimming to fit the Husky seat and base?

    T
    HuskyT, Feb 11, 2010
    #6

  7. frog Husqvarna
    AA Class

    Location:
    MN
    I thought they made white also or used too.No I've never used one,but have used their plastic very good.Give hime a call he might make one in white? Thanks Jon
    frog, Feb 12, 2010
    #7