1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

125-200cc place to start troubleshooting wiring?

Discussion in '2 Stroke' started by d7b, Nov 29, 2013.

  1. d7b Husqvarna
    AA Class

    Location:
    Sydney
    Husqvarna Motorcycle:
    2008 WR250
    Other Motorcycles:
    Sach Madass 125cc +142 big bore kit
    Bike is rocking (2009 wr250) but I have set it up as a motard and connected the indicators / lights etc and no have no power. Checked loom with multimeter and dont seem to get an reading from anything when the bike is running.

    Before I rip out the stator or get filthy, any suggestions where would be a good place to start?

    thanks in advance
    d7b, Nov 29, 2013
    #1

  2. 2premo Husqvarna
    Pro Class

    Location:
    Northern NV
    Husqvarna Motorcycle:
    98 WR360, 1987 WR430, 1988 XC430
    Other Motorcycles:
    Sherco 300, 2002 KTM 380EXC
    unplug everything but the ignition start it and see if you get power from the lighting side
    2premo, Nov 29, 2013
    #2
    d7b likes this.

  3. GusG Husqvarna
    A Class

    Husqvarna Motorcycle:
    2009 WR250 Motard.
    Hi dude,

    I just bought a 2009 WR250 in Motard trim. I have been chasing gremlins all week in the wiring - 10c part caused me grief!!!
    Have you got the wiring schematics, I put them up on my post about testing lights!?

    Having never owned a 2 stroke it was a learning curve - the folks on here will be a HUGE help!!!
    GusG, Nov 29, 2013
    #3