250-500cc Plastic frame Guard for WR300

Anyone know where I can get them. I've done a bit of looking around but can't find any plastic ones I see Motosports have a picture of them on their website but don't list them.

I would also like to know, however that is not a 300 pictured

I bought these.
http://www.husky.com.au/html/products/parts/parts.htm#frame

That is a picture of a 125 and those are stock.

Bummer I was hoping they would be available for the 250-300's. I prefer the look of plastic ones but I guess the metal ones will do the same job.

Or you can make your own with tin snips, a heat gun and and old number plate or body panel and a couple zip ties.

Good job dirt dude, might have to give that a go

Go on the 06 wr125 Redo, I took 09 WR125 ones, trimmed them and also have them on my WR250. I think they are 8.95/9.95 side. Cheap!

eric at p3 said they started making plastic ones and will be available real soon.

Here ya go. Made by p3 and these pics are of eric's wr250.

Someone suggested I give www.waveracing.com a try. They have them available on a make per order basis and within a week they had them made for me.

I must say their customer service was extremely good, even sent me this picture in their email telling me they were made and being shipped tomorrow

Very nice.

Take a look at Kydex thermoplastic, I bought a couple of small peices off ebay. Haven't tried making the guards yet but it doesn't look too difficult

Are those p3 ones available yet? They look nice, where can I get a pair? I hate the look of rubbed off paint on that nice white frame!

Tintman, those look expensive. What did they cost you?
Does anyone have the phone number or web site for P3?

Camstyn, where'd you find em?

They were $104 AUD