125-200cc Powerblade for tmxx38

Can´t find out what item that is for the tmxx38.
Only found for the older kehnin pre2009. (cr125)

Looked alot on this site, but many dead links.

Dosent matter what brand of blade, only I can get i fit.

Thanks,

What about one for a yz 125? Same carb except the yz has a throttle position sensor

Ok, what years did Yamaha has that carb in 125cc?
Anyone know what site powerblade can orderd?

Not easy to choose partnumber...
400, 403 or 406?...

I wouldn't bother with it . Ive got a 39mm TMX with a divider plate and hard to tell much difference to stock

Possibly better playing with needle and slide combinations ie rm needle and 5 slide or doing head mod

I think there is difference if you use all power.

Just today have a RM needle in and working on my '06wr125. Unbelievable improvement over the stock
needle. Inexpensive to try. It is a new bike. Suggest the same test for you Fredrik.

My is a -14 and run perfect. Clean and crisp. When diled in as new.
06 not even the same Carb..
Just need some more power to take the long upstair jump every time.

Anyone know the partnumber for powerblade on the tmxx38?
Thanks

doesn't a blade just give more response ? - on an mx track you should be at full noise so I don't think it will help you clear the jump

Yes it Will help, short bit before the upstair jump, and clear most often but need a bit more.
Please replay only if anyone know where to buy.
Thanks!

i have a TMXX38 carb modified by Hall's with a PowerNow divider plate, spare needles, mains, pilots, slides, etc.

are you interested in full setup or the divider plate only?

Only plate.

OK, i'll pull the carb out of storage and let you know... just want to double check as i sold my WR.