1. 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     TE = 4st Enduro & TC = 4st Cross

Quick way to disconnect lights on SMR 510 for trackday?

Discussion in '4 Stroke' started by Luigic81, Sep 9, 2009.

  1. Luigic81 Husqvarna
    A Class

    Location:
    Hillsboro, OR
    Just wondering if there is an easy quick way, like pulling out a few fuses etc? I would perfer to disable the lights instead of just taping over them. Thanks in advance!! bike is '06 SMR 510
    Luigic81, Sep 9, 2009
    #1

  2. priapism Husqvarna
    AA Class

    Location:
    sherman oaks CA
    Yeah, you just yank the connector out of the back. Mine's an 05 so I don't have blinkers and whatnot, but I can do the swap in about a minute tops.
    priapism, Sep 9, 2009
    #2

  3. Luigic81 Husqvarna
    A Class

    Location:
    Hillsboro, OR
    Sounds easy enough for the headlight, but the tail light and blinkers would be another story. I have a little LED tailight.....
    Is there not just a few fuses I can pull?
    Luigic81, Sep 9, 2009
    #3

  4. priapism Husqvarna
    AA Class

    Location:
    sherman oaks CA
    Honestly for the big bike I just tape over them with painters tape. Disabling them isn't a big deal, you just don't want them shattering if they hit the pavement.
    priapism, Sep 10, 2009
    #4

  5. Luigic81 Husqvarna
    A Class

    Location:
    Hillsboro, OR
    ok gotcha, thanks
    Luigic81, Sep 10, 2009
    #5

  6. So Cal SM450R rider Husqvarna
    A Class

    Location:
    So Cal
    I put a plug under the seat for the tail light and blinkers so I can just unplug it and take out 4 bolts that hold the aluminum bracket, which the tail light and blinkers are mounted to. Its quick and easy to remove/put back on. On the front, I take the glass bulb out of the headlight and run it like that. The front blinkers are leds mounted in my handguards, (Zeta XC's) so I leave those in. :thumbsup:
    So Cal SM450R rider, Sep 11, 2009
    #6