125-200cc radiator ?

Just got my 2002 CR 125 today, however I noticed something odd about the radiator. The left side radiator section goes up at an angle like it has been bent, but it doesn't appear damaged. Is this how it was made or should I start looking for one?

here is a picture

The whole thing looks bent in that pic! As far as I know you're rad should be square and level and not crooked in any way. If it's bent your plastic won't line up.
Ask around locally about rad repair or
http://icwradiators.com/Home.html
https://www.motorcycleradiators.com/

The bottom link posted above by Steve for Mylers is a good place to repair that radiator.

I had them repair the left radiator on my CRF450 a couple of years ago. Turn around was reasonable and it looked like it was never damaged.

Heck of a lot cheaper than paying for a new one too.

Heath

Sweet guys! I would rather get this one repaired then get a Chinese knock off anyhow. This also might explain why the plastic was removed. I'm hoping this bike will run ok after I get it together. I think I should start a project thread.