125-200cc rear wheel bearings

hey guys & gals just wondering if someone can give me the bearing sizes/details for rear wheel of wr125(2013). be same as 250/310 I spose & maybe the 450/510 449/511. need to order/buy tomorrow for an event on sunday & haven't had time to take wheel off to physically check. also do you normally replace the seals & are these generally available at bearing shops? if not ill just reuse the old seals for this weekend. I realise you can get full kits with whole lot but may not have time with postage & doubt bike shop will have them. thanks heaps

You can take the wheel apart and take the bearings and seals to a local bearing house and get replacements over the counter in most cases.

Paw Paw

yeh I know paw paw but its 1030pm here & I need them ordered by tomorrow at the latest & really cant be arsed having to go unlock my bikes, get it on a stand to remove wheel then try punch out bearings/ just wanna make sure I can get them in time or ill take a chance the ones in there

I believe the rear wheel bearing is a 63005 2rs.

25 x 47 x16

is there 3 in there like the 250/300s? 2 drive side 1 non drive. seal sizes?

I don't think there's 3, but I don't know for sure. I just had one out to clean it up, and wrote the number down.

There are 3 bearings and 2 seals. 1 63005 and 2 6005

cheers gots a sol are the 2 seals the same 30-4711? I have the same shitty all balls kit as what you have there but for some reason can only find one seal. worst case ill reuse an old seal I guess. never buying em again but gotta use em up so will buy a quality 63005 & the all balls 6005s

Both seals are the same.

I have not had an issue with these bearings, but I repack them with a good waterproof grease before installing them.

^yeh me too but they seem to fail earlier than the jap brands. may just be time of year/ride conditions that has coincided with their premature demise?! btw the seals aren't 30-4711(30mm id, 47mm od 11mm thick) as written on the bag theyre actually 32x47x7 fyi. thanks for the info mate, much appreciated

Yes, thanks for the info.

edited my above post to show correct sizes after taking seals out today