1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

250-500cc Sealing the WR250 Airbox?

Discussion in '2 Stroke' started by 2whlrcr, May 4, 2009.

  1. 2whlrcr Husqvarna
    A Class

    Location:
    Dubuque, IA
    Anybody figure out a sano way to seal the bottom of the WR 250 airbox? I did a couple of mud races this weekend and discovered my bike sucked some dirt.
    2whlrcr, May 4, 2009
    #1

  2. Norman Foley Husqvarna
    Pro Class

    Location:
    Trumansburg, NY... The Beautiful, Finger Lakes
    Husqvarna Motorcycle:
    82 250WR 86 250WR 93 WXE350 03 TE610
    Other Motorcycles:
    '85 Fantic 300 '12 HUSABERG TE250
    Pretty simple..... Pull your mudflap and caulk the drain slot shut. Then cut a small round hole in the center of the bottom of the airbox. I installed a KTM bulb type drain or you can duct tape it and cut an "X" with razor knife in the tape for a drain. Tape up your airbox sides while your at it.
    Norman Foley, May 4, 2009
    #2