250-500cc Shorter clutch lever for the WR300

I have been looking around on some older posts but didnt see anything real specific. I have lengthened my clutch actuator by 5mm, replaced the OEM garbage clutch cable with a Terminator cable and the clutch is great. I would just like a little bit shorter and more angled clutch lever. right now its like pulling on the long end of a crow bar. That would make life a lot easier for me to do pivot wheelies and what not. I think I read somewhere about an aftermarket KTM clutch lever that would work??
Thanks all

trying to figure out where you are on this
the actuator at the cases, how did you make it longer?
great clutch cable have them on all my bikes
is your clutch perch OEM and as I recall Domino brand?
some of the KTM's used the Domino

I couldn't find a 'shorty' lever so I just cut about an 1" off mine. Works perfect. Just file or sand all the edges smooth.

http://www.cafehusky.com/threads/2011-wr300-bomb-proof-mods.29288/page-3

I added 5mm length to the actuator. Made the pull a little lighter. Yes, I still have the stock perch/lever.

http://www.cafehusky.com/threads/shorty-clutch-lever.27524/

not sure but this seems to be what you were looking for

Thanks

I ended up getting an ARC/Up-Tite shorty clutch lever yesterday. Real nice piece. A lot shorter and fit right on the standard perch. Test ride tomorrow..

Do you happen to have a part number for that lever? I've searched ARC's site hoping to find a shorty lever for my DC-8 perch but never found any shorty levers.

I got it at Toytech. It didnt have a part number on the box but I know he has more.
Scott is the owner.
toytec91cycles@aol.com

The guys at ToyTech are great. I'm in Atlanta and I've used them a couple of times. Phone# 717-469-9484