All 2st Spoke nipple theads

I was hoping somebody on here would know what thread that my 07 WR has on the spoke nipples, i need to replace some

Nobody?

Really, nobody?

I have some you can stop by a measure if you want to.

M4x.7 if I remember right. Thats what SMR spokes had and I'm sure its the same for all the husky models. Let me look for the tap and verify that. It wasnt an awfully common size.

Another FYI, most if not all the spokes and stuff made in the aftermarket are gauge size if I'm not mistaken.

I might have a few extra nipples laying around too, I can check to see if they're still here..

Thanks, I just don't want to pull it apart just to check the size

For future reference, you could always undo it and leave the nipple in the wheel, pinched down by the tube, and slide the spoke out the hub to use to measure

Might be a few hours before I can report back with the answer, But I'll let ya know asap.

Back off one nipple and use a thread pitch gage, removal not required.

Very true if ya have a gauge handy

Sorry for the delay, I haven't found any nipples but I'm still looking. As for the threads, they are M4.5x.75

Thanks for the reply's, if I can break one loose i with check with my pitch gauge, I just don't want to wreck another, just like to have them on hand so i can replace them. I'm running a tubeless system, need to get the replacement rim tape before I start pulling them out

just got some OE nipples and spokes for my '07wr- dealers will have them in stock

Not my dealer, he couldn't even find a linkage kit for my bike, I even gave him a part # and he said he couldn't get it. The problem is that existing dealers are trying to take on Husky with no knowledge of the bikes, it's great they are selling them but with no support.

rob@rossrochersales.com if you need something for your bike. We stock linkage kits and spokes.