125-200cc Steering Damper for 2013 wr125

Is anyone running a damper on a 2013? If so dis you havwnto gring the welds?

I would really like to run a samper but dont want to have to grind winds to mount the pin.

I have a scotts on my '09 (same frame) and had to grind the weld a little bit. It really is not an issue.

What about the brp under mount?

Is the top triple clamp the same on the 13 as the '09 to '11

I have newer forks/triples on my 09 (kyb sss forks vs 50mm marzocchis it had) and the sub mounts were not the same, but the frame mount is the same part (and is the part that may or may not require the frame weld to be ground down slightly)

I'm about to mount a GPR on my 14 CR. I'll keep you posted. Initial fitment on my 12 TE 310 required some relieving of material from the ID of the damper mount as the weld on the frame was bit bulky.

which damper mount

I did not have to grind the frame on my 09' CR125 to fit the Scott's bolt on tower.

I'm selling the SUB mount and tower if anyone is interested.

I'm interested

Tried installing the GPR stabilizer utilizing the mount for the TE 310... No bueno.. Head tube is much smaller diameter. Just eyeballing it, it wasn't that obvious...

Contacted GPR, sounds like they do not offer a mount as they apparently had to grind the frame weld down a bit. Anyone have any leads on a mount for a 14 CR125?