250-500cc Trailtech Vapor Stealth WR300

I looked around at some old posts and didnt find anything specific. I have a Trailtech Vapor Stealth to mount on my 2012 WR300. Looking for some ideas/posts/pictures/etc on powering the computer. I dont have a headlight on my bike. Appparently have to power it from the stator. Appreciate any details on this.
Thanks

The Vapors do not "need" bike power; you can run them off the internal battery if you want.

That being said, even without a headlight, your 2012 should have the factory reg/rec because it has the Ducati ignition. Under the tank there is an "extra" wire, which normally plugs into the headlight harness, which should be +12V power. You can probably utilize that! I believe it is the yellow wire, but I am not 100% certain. In any case there should only be one wire hanging off the reg/rec, just double-check it with a multimeter.

I know there were other posts on here somewhere showing the wiring diagram for the lights, but I don't recall where. You can try to dig one of those up.

Excellent info!
Thanks

Here's what I'm just starting to do ...

I purchased an extra battery and a wall charger ... The charger plugs into the unit same as the hot wire for the device. This device is about essentialx2 for me if I'm going to return to some of the places I stumble across ...And its always cool to look at where you went on the last ride ... Sometimes with some helmet cam footage, you can follow the map and watch a video of the area also ...

These guys (Justin) give very good email service for sure and support ...


Any one know where the hot leads off the stator are at on a 010 TC250? I'd like to have this also as a backup plan...

I ran the Vapor off the yellow plug described in this thread. Works great. I entered 2205 on my wheel size too. That sound about right?

I'm not sure the TC has the lighting coil wound onto the stator as it is a motor cross model.