1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

250-500cc wheel bearings

Discussion in '2 Stroke' started by LBBKserg, Mar 13, 2020.

  1. LBBKserg Husqvarna
    A Class

    Location:
    Washington
    Husqvarna Motorcycle:
    2010 300wr
    Other Motorcycles:
    05crf450,07yzfr6,08xcf-w250,01exc525
    my 2010 wr300 needs wheel bearings any recommendations and am i going to need any special tools for the job other than drivers?
    LBBKserg, Mar 13, 2020
    #1

  2. 2premo Husqvarna
    Pro Class

    Location:
    Northern NV
    Husqvarna Motorcycle:
    98 WR360, 1987 WR430, 1988 XC430
    Other Motorcycles:
    Sherco 300, 2002 KTM 380EXC
    the biggest and most important recommendation I can offer
    DON'T buy Chinese bearings


    you can refer to a service manual or often to the owners manual on important info
    they built it they know it!
    2premo, Mar 14, 2020
    #2

  3. Hurky Husqvarna
    AA Class

    Location:
    Spain
    Husqvarna Motorcycle:
    ex: WR300 2010
    Other Motorcycles:
    Honda CR500AFX + Beta RR300
    Good quality bearings are more expensive but they do hold up longer, but I normally use those Kit's from ProX and they hold up OK.

    You also need some pliers to remove one big circlip on the rear wheel.

    If you want to get them at at an industrial bearing shop, get on this site and check for the measurements:
    https://shop.italhusky.com/en/products/2010/wr-250-300-4

    Cheers !
    Hurky, Mar 16, 2020
    #3

  4. jeanjean Husqvarna
    AA Class

    Location:
    Netherland
    Husqvarna Motorcycle:
    WR 125
    Other Motorcycles:
    IT175H
    Rear right: 63005 (25x47x16) ~15.00 €/piece
    Rear left: 6005 (25x47x12) ~4.50 €/piece
    Front; 6004 (20x42x12) ~3.50 €/piece

    Prices are for quality bearings (SKF / FAG / KOYO / NTN)

    Prices should be similar in $

    jeanjean
    jeanjean, Mar 16, 2020
    #4
    Chisler likes this.