wheels from former modelyears for 2009

I could buy a wheelset from a 2003 modelyear TC 250. I am not quite sure if the wheels fit into my 2009 TE 310.

any ideas?

The rear will not fit. The sprocket flange on the rear hub of the 09's are approx 10mm thicker that previous years. If you look closely you can see the casting mark where they made the modification. The front should work though.

Husky144 you just saved me about $200.00. I am building a spare set of wheels and now I am going to have to look at the rear again. I swore I swapped my '07 WR 250 wheel with the '08 TE but now I am going to look. So are you saying that with the newer wheel that the sprocket would stick out further then?

Your 07 wheel should fit your 08. The only thing I am sure is that the 08 and 09 hubs are different on the bikes with new chassis. I think they added 10mm to the sprocket flange of the rear hub. I would double check the part number but I ran into this same issue when I built my set 2 months ago.

So to answer your question, yes, the sprocket would be misaligned with the countershaft sproket.

Hope that helps.

Very Strange then, According to the parts fiche a 2002 WR 250 has Hub assembly listed as part number 8A0096937 and the 2008 and 2009 TC/TXC/TE list the same part number for Hub assembly 8A0096937. I am going to do some measuring tomorrow.

I can't see a 10mm difference between my 08 and my earlier bikes. So it may be late 08s that are different?

The hubs on my 09 wr 125 are the same as my 08 TXC 250.