Like the tittle says. i find that every 3-4 weeks of daily riding, i have to make the chain tighter and i don't know why. i have tried to tighten the axle nut more, in-case that might help but it hasn't. Any suggestions?
Are you locking out the adjuster nuts against each other after tightening the axle? Is the chain new? Are you checking the tension with weight on the seat, off the seat, bike on a stand, bike on a sidestand, etc..?
Chains usually require very little adjustment during most of their lives. If you are adjusting a lot it'is a sign that your chains life is near its end. OEM chains aren't generally of the highest quality.
i am locking the lock nuts. the chain is not new but the rear sproket is. it has the same number of teeth as the last one. and i check the tension when the bike is vertical without putting weight on the seat.
Yes it's an o-ring chain. the front sprocket is tight. i honestly have no idea why it keeps loosening. the chain may just be at the end of its life, that's the only reason i can think of.
It is not a good idea to replace a sprocket and not a chain. They wear out together. Your chain is likely at the end of it's service life, and damaging the new sprocket trying to match.
Yeh thats a rule of thumb with bikes. Do the sprockets and chain together. If theres not much life in the chain id put a new one on 'er
A high compression thumper has extreme firing impulses that need to be absorbed somewhere. Riding in the dirt they are absorbed to a great degree, but on hard packed or pavement not so much, so basically everything between the piston and the rear tire need to do it.. Countershafts, sprockets and chains are the first to show extreme wear. I just put a second generation Kush sprocket on my TE610 and I can feel the difference, but a cush hub (like Norman says) is the real answer.. They used to be OEM on the 610s....
you ensure your chain is at the correct tension, you need to compress the suspension so the countershaft, swingarm pivot, and rear axle are in line with each other. this is when your chain is at its tightest. here is where you set your tension, ensuring its not too tight or too loose.
This. My guess is that you are over tightening, and when you load the suspension, you're stretching the chain. There should be slack through the full suspension travel. It will appear "too loose" sitting on the side stand..
i suppose that is possible. when i get a new chain, im going to check the bike manual to make sure i do it right.
I'm off road only on the 610 and I leave my chain on the loose side. I can make it touch the swing arm where the plastic chain guide ends at the bottom. I also had a 50 t rear sprocket, with a smaller one ( 45 t ) it would touch easy. If your pulling the chain tight, that's no good!
