Will this work on '82-'83 ??

I would think so but it says up to '81 and want to put on the '82 500CR and the '83 250CR. Thanks

If it's aluminum I'd be worried it wouldn't stand up to either the grinding/grit on the cable end or the torque on the shaft end. That said, almost all the clutch actuator arms were the same

says it's 6061 billet.....here you go, appears to be same as huskyjunk.com

http://stores.shop.ebay.com/HUSKY-JUNK__W0QQ_armrsZ1

Rhett
I have one you can try when you get your 83.
Was going to use it on my 74 Mag but I'm not
at this time.

Richard

Richard, thanks I'll take you up on the offer. How did Cycle Ranch go ? Awesome track always have a good time there even though I seem to crash there a lot. Have you seen this one , going to try to get out to Rio this weekend if possible but with baseball and Mother's Day might be tight. Thanks again

http://houston.craigslist.org/mcy/1150239880.html


On another note, i think I just feel in love......

http://cgi.ebay.com/ebaymotors/Husq...010QQitemZ200339659128QQrdZ1QQsspagenameZWDVW

I looked at these levers from Husky junk.
The thing that i dont like about it for my application is that it is straight.
My lever has a dog leg bend downward as to clear the carb bowl M.J. nut.

my clutch actuator arm/lever is made from stainless and has the same dimensions as the lever introduced on the 1985 models and used up to 1989. lever can retrofit engines back to 1975. lever also has a corrective stepped bend for proper cable alighnment.