125-200cc wr 125 2006 throttle cable routing

any one have a picture or diagram of how the throttle cable should be can propperly on a 125.iv a cable coming before a race this weekend and i was having snagging issues last weekend and need to know the corect way to route it

thanks

Normally up under tank follows frame and out beneath bar pad inbetween bar clamps then to lever.
Make sure the cable doesnt snagg or pull on the tank when you put it back on.
Zip tie it to the underside of frame.

And I have two, and one runs beneath bar pad and the other this side of it and throttle twisted backwards, both work well both have issues. Not a clear favourite and suggest the same for most bikes if handlebars stayed still !! I do shield mine around tank / pipe area though.

I rerouted mine with Lectron and new cable like juicy says except mine goes between top engine brace. Lectron doesn't have the 90 degree nipple like the stock carb.

I just installed a new throttle cable and routed between the top engine brace as well- it's a stock Mikuni carb, then under tank, (front brake side) between bar clamps to housing.

Only problem is rotatin carb for adjustment with cable between head stays

Good point. The cable if undone on the housing makes that easy, but to your point another step...

Another step? Run the cable up above the head stay and along frame.
Or don't adjust your carb.

I dont jet/rejet much.... I run mine between head stays up backbone on left side and behind the triple trees to the housing.....

I'm routed through he supports and can still rotate the carb to remove the slide, or access the bowl.